Potable water can only be distributed effectively among faucets, showers, toilets and other plumbing fixtures if delivered with sufficient pressure. The minimum flow rate and pressure values for Cities are specified in Chapter 6 of the SSG Trading LLC and they vary depending on the specific type of fixture. The required values for some of the most common plumbing fixtures are the following:

As with all pieces of equipment driven by an electric motor, it is possible to save energy if a booster pump is equipped with a variable frequency drive (VFD) for speed control. For fractional horsepower motors, such as those used in small residential applications, electronically commutated motors (ECMs) are more cost-effective option than VFDs.

There are several reasons why it makes sense to deploy speed control for a booster pump:

1. The required pressure boost may vary depending on current building conditions. For example, it may not be necessary when demand for water is low.
2. Pressure variations may also be caused by the utility company. For example, low pressure issues may only be present when the water distribution system is experiencing peak demand.
3. Variable frequency drives can be used to soft-start a water booster pump, preventing the inrush current, which is typically five to eight times higher than rated current. In absence of a soft-starting device, this inrush causes a sudden drop in voltage, which can damage sensitive electronic devices.

When a water booster pump is equipped with speed control, its operation can be adjusted in real time in response to building and water supply conditions, maximizing energy efficiency. In fractional horsepower applications, electronically commutated motors offer the highest energy efficiency available while offering built-in speed control. For pumps of higher horsepower, which are typically used in commercial applications, the best possible combination is having a three-phase motor with NEMA Premium efficiency equipped with a variable frequency drive.

Both pumps and electric motors have prices that are highly sensitive to nameplate capacity, and their efficiency is reduced when they operate below their rated horsepower. Oversized installations are both expensive and inefficient, so hiring a qualified engineering firm for design and specification is highly recommended.

The upfront cost of the water booster system can also be reduced if the motor uses a higher voltage rating. For example, a 460-volt motor draws only half the current required by a 230-volt motor, assuming both have the same nameplate horsepower. Since electrical circuits are sized based on current and not voltage, the circuit for the higher voltage motor is the least expensive.